Installation; Product Description - Johnson SECADORA JSC8AA Manual De Usuario

INSTALLATION

Product Description

Top board
Container
Power Cord
Drum
Filter door
Note: Please see the products you purchased in kind prevail.
Accessories
The following parts are optional for specific models.
If your dryer has following parts, please wear gloves and
following the instruction below .
Hose holder(optional)
Condensing drain
hose(optional)
Installation
Use pliers to remove Insert the
the drain hose from external
the hose connector. drainage
hose.
V.1
Control panel
Door
Air inlet
Filter base
Maintenance cover
install them
Put the hose holder on the washing
basin or any other sink.
7
INSTALLATION
Transport
Move cautiously. Do not grasp any salient parts of machine. The machine
door can not be used as the handle for delivery. If the dryer can't be transported erectly,
the dryer could be slant to right less than 30°.
Installation Position
1.It is recommended that, for your convenience, the machine is positioned close to
your washing machine.
2.The tumble dryer must be installed in a clean place, where dirt does not build up.
Air must be able to circulate freely all round the appliance. Do not obstruct the
front air inlet or the air intake grilles at the back of the machine.
3.To keep vibration and noise to a minimum when the dryer is in use, it should be
placed on a firm and level surface.
4.The feet must never be removed. Do not restrict the floor clearance through
deep pile carpets, strips of wood or similar. This might cause heat built-up which
would interfere with the operation of the appliance.
Level Adjusting
Once in its permanent operating position,
check that the dryer is absolutely level with the aid
of a spirit level. If it is not, adjust the feet with a tool.
Power Supply Connection
1.Make sure that the voltage of the power supply is the same as the electric specification
of the dryer.
2.Do not connect the dryer with the power connection board, the universal plug or socket.
V.1
8