Programming Stop - Teuco Hydrospa 620 Manual Del Usuario

PROGRAMMING STOP

Owing to reasons related to technical service requirements, the program execution may be stopped.
Avoid to use this function. Shut off power, if necessary.
The function is described anyway, as sometimes the system may automatically stop for technical or safety
reasons (e.g. power supply voltage surges).
ENTRY
• Press the "Menu/OK" key.
• Using the keys ▲▼, select the "Run/Stop" menu.
• Select "YES" on the string "Programming stop".
• The display shows:
BLOCK RELEASING
• Press the "Menu/OK" key.
• Using the keys▲▼, select the "Run/Stop" menu
• Press the "Menu/OK" key.
• Using the keys ▲▼ select the string "Con ini non
volatile"
• Press the "Menu/OK" key to confirm.
620
12:34 01/03/2015
STOPLD
DATE
12345678
EN
41