Genesis GDP1012A Manual Del Operario página 9

REMOVING THE CHUCK AND ARBOR
(FIG 8)
1. unplug the machine from the power source.
2. Raise the table until it is about 7 inches below the chuck.
3. Lower quill by using the down feed handles.
4. Rotate spindle to align the key hole in the spindle with the key
hole in the quill.
5. Insert the drift key (J) into the aligned slots and tap lightly. The
chuck and arbor assembly should fall from the spindle.
ADJUSTMENTS
WArNINg:
switched off and unplugged from the power source
before adjusting, adding accessories, or checking a
function on the tool.
ADJUSTING SPEEDS AND BELT TENSION
(FIG 9, 10)
1. unplug the machine from the power source.
2. open the drill press pulley cover (1).
3. Loosen the belt tension knobs (13) on the each side of the drill
press head assembly.
4. Pull the motor (2) as close to the column (C) as possible.
5. Change the belt locations according the speed chart (fIG 10)
and speed you desire.
6. Push the motor away from the column (C) to tension the belts.
7. The belt (17) should be tight enough to prevent slippage. Correct
tension is set if the belt flexes about 1/2" when thumb pressure
is applied at the midpoint of the belt between the pulleys.
8. Tighten the belt tension knobs (13).
ADJUSTING TABLE HEIGHT (FIG 11)
1. Loosen the table support lock handle (7).
2. Turn the crank handle (6) to raise or lower the table to the
desired height.
3. Tighten the lock handle (7) before drilling.
ROTATING THE TABLE ASSEMBLY
AROUND THE COLUMN (FIG 11)
1. Loosen the table support lock handle (7).
2. Rotate the table assembly (8) around the column to the
desired position.
3. Tighten the lock handle (7) before drilling.
ADJUSTING TABLE BEVEL (FIG 11,12)
The table can be tilted 0° to 45° to the left and right.
1. Loosen the bevel lock bolt (B4) with a wrench.
2. Tilt the table (8) to the desired angle, using the bevel scale (19)
as a basic guide.
3. Re-tighten the bevel lock bolt (B4).
4. To return the table to its original position, loosen the bevel lock
bolt. Realign the bevel scale (19) to the 0° setting.
5. Tighten the bevel lock bolt (B4) with the wrench.
Always be sure that the tool is
J
FIG 8
17
1
C
FIG 9
FIG 10
19
8
6
FIG 11
8
B4
FIG 12
1
2
13
7
9