Kindcomfort KZ123 Manual De Uso página 13

4. Fasten the belt, ensuring that the lap belt goes through
under both armrests and that the diagonal shoulder belt passes
through B guide and J guide under the armrest that is next to the
vehicle anchor point. You will hear a "click" when this is properly
fastened. Ensure that the belts are not twisted and tighten by
pulling the diagonal shoulder belt upwards (4.4).
It is advisable to continue using the seat backrest until the child's
height exceeds the headboard.
5. ADJUST THE HARNESS TO THE HEIGHT OF THE CHILD.
Always check that the harness straps are suitable for the height of
your child. The shoulders of the child should always be just below the
back slots at a suitable height (5.1).
Changing the harness height
1. Adjust the height of the harness, by pressing the harness
adjustment button and pulling the harness straps towards you to
loosen them (5.2).
2. Then unhook one of the harness connector straps
of the seat and pull the loose strap towards the front of the seat
(5.3, 5.4 y 5.5).
3. Insert the harness strap into the
at the front of the seat. Then insert the harness strap into the
appropriate upper or lower slot at the rear of the seat (5.6).
4. Reinsert the harness strap in the harness connector
of the seat (5.7).
5. Then, do the same with the other harness strap. Verify that the 2
harness straps go through the slots at the same height.
Fastening the harness
1. Join the 2 buckle metal connectors (5.8).
2. Pass both connectors through the slot in the upper part of the
buckle until you hear a "click" (5.9).
3. Always make sure the harness is properly fastened by pulling the
harness straps upwards.
4. To unfasten the harness press the red button on the buckle
downwards (5.10).
24 Child restraint system
J guide
Q at the back
M slot of the fabric and backrest
Q on the back
KZC123
Tightening the harness
1. Pull the harness straps up to remove the slack from the lap section
of the harness, then pull the harness regulating strap until the
harness is fully stretched (5.11).
2.The harness should be as tight as possible without causing
discomfort to your child.
3. Make sure the lap section of the harness is positioned as low as
possible, surrounding your child's hips and not his stomach.
4. A harness that is not properly tightened can be dangerous. Check
the harness adjustment and tighten whenever you put your child in
the child safety seat.
Loosening the harness
1. The harness is loosened by pressing the adjustment button of the
harness (under the seat cover) at the front of the seat. (5.12)
2. Press the lever that is marked with "press" down with one hand
while holding both harness straps with your other hand.
3. Pull the harness straps towards you to loosen the harness.
4. Be careful when adjusting the harness strap not to trap the harness
adjustment strap when you press the button down.
6. SEAT AND HARNESS REMOVAL.
Remove the seat harness
1. From the back of the seat, unhook the
connector tapes and detach the harness from the metal connector
of Q harness, pull the Q connector tape to detach completely from
the seat 6.1, 6.2 and 6.3).
Remove the cover buckle protector and the lower harness
1. Pull the base tape to detach it from the seat (6.4).
2. Turn the plate attached to the safety buckle so that they coincide
with the nearest slot and insert into the slots of the seat base and
then pass through the slots in the cover (6.5).
Group 1/2/3
EN
N harness protector
www.kindcomfort.com 25