DeWalt DXPW4240 Manual De Instrucciones página 13

wand, refer to Spray Wand Nozzles. NOTE: Chemicals and soaps
will not siphon if the black soap nozzle is not installed on the spray
wand.
4. After use of chemicals, place chemical hose into container of clean
water and draw clean water through chemical injection system to
rinse system thoroughly. If chemicals remain in the pump it could
be damaged. Pumps damaged due to chemicals will not be
covered under warranty.
WARNING: To reduce the risk of injury, read the pressure washer
instruction manual and the engine instruction manual before starting
pressure washer.
DANGER: Risk of fluid injection and laceration. When using the
high-pressure setting, DO NOT allow the high-pressure spray to come
in contact with unprotected skin, eyes, or with any pets or animals.
Serious injury will occur.
enough to penetrate human and animal flesh, which could result
in amputation or other serious injury. Leaks caused by loose
fittings or worn or damaged hoses can result in injection injuries.
DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a
physician immediately!
DANGER: Carbon Monoxide. Using an engine indoors can kill
you in minutes. Engine exhaust contains high levels of carbon
monoxide (CO), a poisonous gas you cannot see or smell. You
may be breathing CO even if you do not smell engine exhaust.
En gine exhaust con tains carbon mon ox ide, an odorless and
deadly gas.
en closed areas such as ga rag es, base ments, etc.
animals.
WARNING: Risk of fire, asphyxiation and burning. Never fill fuel tank
when engine is running or hot. Do not smoke when filling fuel tank.
bottom of filler neck to provide space for fuel expansion. Wipe
any fuel spillage from engine and equipment before starting
engine.
fler during or immediately after use of your pressure washer.
Damage to hoses from contact with hot engine surfaces will
NOT be covered by warranty.
NOTICE: Never pull water supply hose to move pres sure washer.
This could damage hose and/or pump inlet.
DO NOT use hot water, use cold water only.
turn water supply off while pressure washer engine is
running or damage to pump will result.
DO NOT stop spraying water for more than
two minutes at a time. Pump operates in
bypass mode when spray gun trigger is not
pressed. When the temperature inside the pump
rises too high the thermal relief valve (T) will open
and release a gush of water in an effort to lower
the temperature inside the pump. The thermal
relief valve will then close. If pump is left in bypass mode for
more than two minutes internal components of the pump can
be damaged.
13
-
T