Grounding Instructions; Additional Safety Rules - Makita 7104L Manual De Instrucciones

be properly repaired or replaced.
20. DIRECTION OF FEED. Feed work into a blade
or cutter against the direction of rotation of
the blade or cutter only.
21. NEVER LEAVE TOOL RUNNING UNATTENDED.
TURN POWER OFF. Do not leave tool until it
comes to a complete stop.
22. REPLACEMENT PARTS. When servicing, use
only identical replacement parts.
VOLTAGE WARNING: Before connecting the tool to
a power source (receptacle, outlet, etc.) be sure the
voltage supplied is the same as that specified on the
nameplate of the tool. A power source with voltage
greater than that specified for the tool can result in
SERIOUS INJURY to the user- as well as damage to
the appliance. If in doubt, DO NOT PLUG IN THE
Ampere Rating
More Than
0
6
10
12
000173

GROUNDING INSTRUCTIONS:

This tool should be grounded while in use to protect
the operator from electric shock. The tool is
equipped with a
three-prong grounding type plug to fit the proper
grounding type receptacle. The green (or green and
yellow) conductor in the cord is the grounding wire.
Never connect the green (or green and yellow) wire
to a live terminal. Your unit is for use on 120 volts
and has a plug that looks like Fig. "A".
Fig. A
Grounding
Blade
000088
Table 1: Minimum gage for cord
Not More Than
6
10
12
16
three-conductor cord
Cover of Grounded
Outlet Box
APPLIANCE. Using a power source with voltage less
than the nameplate rating is harmful to the motor.
USE PROPER
three-wire extension cords that have three-prong
grounding-type plugs and three-pole receptacles that
accept the tool's plug. Make sure your extension
cord is in good condition. Replace or repair damaged
or worn cord immediately. When using an extension
cord, be sure to use one heavy enough to carry the
current your product will draw. An undersized cord
will cause a drop in line voltage resulting in loss of
power and overheating. Table 1 shows the correct
size to use depending on cord length and nameplate
ampere rating. If in doubt, use the next heavier gage.
The smaller the gage number, the heavier the cord.
Volts Total length of cord in feet
120 V 25 ft.
18
18
16
14

ADDITIONAL SAFETY RULES

1. Use this tool only to cut holes in wood.
and
2. This tool is for cutting holes in flat-surfaced
wood. Never use it for cutting holes in a log.
3. Wear ear protectors.
4. Handle the cutter chain carefully; it is very
sharp.
5. Place the workpiece on wood blocks or short
beams to prevent the cutter chain from hitting
the ground, floor, etc., causing damage to the
cutter chain at the time of hole breakthrough.
6. Check the cutter chain carefully for cracks or
damage before operation.
Replace cracked or damaged cutter chain
immediately.
7. Secure the tool to the workpiece firmly.
8. Inspect for and remove nails or foreign matter
from the workpiece before operation.
9. Do not operate the tool with the safety cover
open.
10. Do not wear gloves during operation.
11. Keep hands away from moving parts.
12. Remove the tool from the workpiece after
operation to keep it from falling off and
possibly causing injury.
3
EXTENSION CORD.
50 ft. 100 ft.
AWG
16 16
16 14
16 14
12 Not Recommended
Use only
150 ft.
14
12
12
USB091-1