Replacing Carbon Brushes - Makita 7104L Manual De Instrucciones

(3) (2) (1)
(6) (5) (4)
006012
WARNING:
Never attempt to enlarge a hole with the cutter
•
chain still within the hole. This will cause
unstable and dangerous operation.
Never angle the cutter chain when cutting the first
•
hole, or a dangerous kickback may result. Always
have the cutter chain set to the perpendicular
position when cutting the first hole.
Lap joints up to 130 mm (5-1/8") can be cut with this tool.
006013
NOTE:
Lap joints can be cut only on the front (side away
•
from you) of the workpiece.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.

Replacing carbon brushes

001145
1. Front base
1
1. Limit mark
1
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
006014
Lubrication
After use, remove dirt, chips and foreign matter adhering
to the tool. Then oil the moving parts (especially cutter
chain) and the contact portions.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always
using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Cutter chain
•
Chain bar for 30 mm (1-3/16")
•
Sprocket 4 for 30 mm (1-3/16")
•
Oil supply (100 cc)
•
Wrench 13-17
•
7
1. Brush holder
cap
1
2. Screwdriver
2
or attachments
Only use accessory or
are