Taurus MITHOS TITANIUM Manual De Uso página 16

- You can restart the appliance using
the switch, but once the control devi-
ce has cooled, if it has not restarted
do not force it and leave it to cool.
How to cut the hair:
- Situate the person whose hair you
are going to cut so that the top of
their head is at your eye level.
- To obtain best results is better to
use the appliance on dry hair, as it is
much easier to control the hair and
the result.
- Hold the appliance in a calm and
relaxed manner in order to ensure
maximum control of the cut and a
uniform result. Proceed to use short
cuts gradually going around the
head.
- Leave the hair a little longer than
desired length as it can always be
altered later.
- While working adapt the comb /
comb guide to the desired result.
- At regular intervals, stop cutting in
order to comb the hair and check the
results so far.
Step 1 Nape:
- Attach comb guide size: 3mm o
6mm.
- Hold the appliance with the razor
facing downwards and begin to cut
the hair from the base of the neck.
- Make some upward movements,
raising the appliance gradually and
away from the head, cutting the hair
gradually until the height of the ears
(Fig. 3)
Step 2 The back of the head:
- Attach comb guide size 9-12mm
and continue with the back of the
head (Fig 4)
IM Mithos Titanium i Plus.indb 16
Step 3 The side of the head:
- Attach comb guide size: 3mm o
6mm to trim the sideburns.
- Attach the longest comb guide size
9mm/12mm again and continue until
you reach the top of the head.
Step 4 The top of the head:
- Attach comb guide size 9mm or
12mm, pass the appliance from the
back to the front, against the growth
of the hair (Fig 5). In some cases
it's necessary to go over what you
have done a second time from front
to back.
- Attach comb guide size 3mm or
6mm when you want to achieve a
more precise cut.
- Use comb guides size 9-12mm to
leave hair at a longer length. Hold the
hair up with the comb or the comb
and your fingers and cut.
- Always work from the back to the
front reducing the length between
your fingers or the comb and the
head gradually.
Step 5. Final touch
- Finally use the appliance without
attaching any comb guides to the bla-
des to cut the hair around the base
of the neck, the sides of the neck and
the ears.
- To make the sideburns straight, turn
the appliance over to use the upper
blades (Fig 6). Move the appliance
adapting it the physiognomy of the
head.
Once you have finished using the
appliance:
- Turn the appliance off, using the on/
off switch.
2/10/15 9:51