Outside Back Exhaust - GE KITCHEN HUB UVH1301 Manual Del Propietario E Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

C. OUTSIDE BACK EXHAUST
INSTALLATION OVERVIEW
C1. Prepare Rear Wall
C2. Attach Mounting Plate to Wall
C3. Prepare Top Cabinet
C4. Adjust Blower Exhaust
C5. Assemble and Install Adapter
C6. Mount the Kitchen Hub™
C7. Finalize Installation
C1
PREPARING THE REAR WALL
FOR OUTSIDE BACK EXHAUST
You need to cut an opening in the rear wall for
outside exhaust.
TEMPLATE.
previously drilled for holes A and B in the
mounting plate.
REAR WALL TEMPLATE.
ATTACH THE MOUNTING PLATE
C2
TO THE WALL
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to
a wall stud.
49-2000492 Rev. 2
Installation Instructions
(Horizontal Duct)
C2
ATTACH THE MOUNTING PLATE
TO THE WALL (Cont.)
1. Remove the toggle wings from the bolts.
2. Insert the bolts into the mounting plate through the
holes designated to go into drywall and reattach the
To use toggle bolts:
Spacing for Toggles More
Than Wall Thickness
Toggle Wings
Mounting
Toggle
Plate
Bolt
Wall
3. Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount
the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly centered
under the cabinet.
CAUTION
Be careful to avoid pinching fingers
between the back of the mounting plate and the wall.
4. Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
Bolt
End
25

Publicidad

Tabla de contenido
loading

Tabla de contenido