GE KITCHEN HUB UVH1301 Manual Del Propietario E Instalación página 14

1. PLACEMENT OF THE MOUNTING PLATE
A REMOVING THE KITCHEN HUB™
FROM THE CARTON/REMOVING
THE MOUNTING PLATE
Remove the packaging
CAUTION
Wear gloves to protect against
sharp edges.
1. Open the box and fold back all four carton
flaps fully against the carton sides. Remove the
following items from the protective foam: charcoal
filters, cord plug, damper, and screws. Do not
remove the foam protecting the front of the unit.
2. Carefully roll the unit and carton over onto the top
side. The unit should be resting in the foam.
3. Pull the carton up to remove.
Foam
4. The mounting plate is attached to the back of
the unit. Remove the two screws holding it to
the back. The plate will be used as the rear wall
template and for mounting the unit to the wall.
Screws
5. Set the unit upright. Remove and properly discard
plastic bags and foam.
14
Installation Instructions
Mounting Plate
B
FINDING THE WALL STUDS
Center
1. Find the studs, using one of the following methods:
A. Stud finder
B. Use a hammer to tap lightly across the
Carton
mounting surface to find a solid sound. This will
indicate a stud location.
2. After locating the stud(s), find the center by probing
the wall with a small nail to find the edges of the
stud. Then place a mark halfway between the
edges. The center of any adjacent studs should be
3. Draw a line down the center of the stud.
IMPORTANT: The unit must be installed to at least
one wall stud.
Wall
Studs
OR
49-2000492 Rev. 2