Inserting Wire-End Ferrules; Changing The Wire-End Ferrule Reel - Weidmuller Crimpfix E Manual De Instrucciones

Setting up the machine
5.4 Inserting wire-end ferrules
1. Set up the wire-end ferrule role so that clockwise unrolling
is ensured.
2. Turn the lock on the front flap to open it.
3. Swing the front flap to the side.
3.
Figure 5.6 Positioning the wire-end ferrule
Figure 5.7 Threading wire-end ferrules into the transport unit
38
The transport bolt (figure 3.3, 2) in the transport unit must be
fully underneath. See also the sticker on the transport unit.
The transport bolt is pressed downwards by a spring.
If it is not fully down:
► Check if the transport bolt is blocked, and remove the
► Push the wire-end ferrule belt into the transport unit
1.
► Check for firm fitting by pulling the wire-end ferrule
► Close the front flap using the front flap lock.
2.
► Roll up the loose wire-end ferrule belt.
5.5 Changing the wire-end ferrule reel
► Turn the lock on the front flap to open it.
► Swing the front flap to the side.
► Press the transport bolt (figure 3.3, 2) fully upwards,
► See section 5.4.
block if necessary.
just until the lowest sheath latches in.
There must be no sheaths protruding downwards.
belt carefully.
and pull the wire-end ferrule belt out of the transport
unit.
2516390000/03/07.2018