Bosch JSH180 Instrucciones De Funcionamiento Y Seguridad página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2610051978.qxp_JSH180 3/16/20 8:33 AM Page 10
the RIGHT (as viewed from the bottom
of the jig saw)
Step 2 – Continue the rotation unto
fingers will snap into the correct open
position.
The clamp is now ready for use.
Attaching JA1011Steel
Overshoe (Sold separately)
Your tool is equipped with a protective
plastic overshoe that protects finer
surfaces. An optional heavy-duty steel
overshoe for work in rough conditions is
sold separately.
To attach, slide overshoe in direction of
arrow completely onto metal footplate
(Fig. 4).
Anti-Splinter Insert
To minimize splintering of the top
surface of the material being cut, place
the JA1013 anti-splinter insert in the
blade opening of the footplate's plastic
overshoe (Fig. 5).
Note: This insert will only work with
accessories. Such preventive safety measures reduce the risk of starting the tool
accidentally.
Switch Lock
The switch lock is designed to prevent
accidental starts. To operate switch,
press the switch lock button with your
thumb to the unlock
the switch, press the switch lock button
to the lock
Variable Speed Trigger
Switch
Your tool is equipped with a variable
speed trigger switch. The tool can be
turned "ON" or "OFF" by squeezing or
releasing the trigger. The speed can be
adjusted from the minimum to maximum
nameplate SPM by the pressure you
apply to the trigger.
pressure to increase the speed and
Assembly
Operating Instructions
Disconnect battery pack from tool or place the switch in the locked or
off position before making any assembly, adjustments or changing
symbol. To lock
symbol (Fig. 1).
Apply more
Fig. 4
JA1011 STEEL
OVERSHOE
Fig. 5
FOOTPLATE
JA1013 ANTI-
SPLINTER INSERT
blades that have ground sides such as
T301CD, TB1B, T101D, and T101DP.
release pressure to decrease speed
(Fig. 1).
Work Light
Your tool is equipped with work light for
better visibility during operation. When
the tool is turned on, the light turns on.
When the tool is turned off, the light
turns off.
Chip Blower
Your jig saw is equipped with an "always
on" blower to help keep the intended
cut line visible. . When the tool is turned
on, the blower is turned on. When the
tool is turned off, the blower is off.
-10-
FOOTPLATE'S
PLASTIC
OVERSHOE

Publicidad

Tabla de contenido
loading

Tabla de contenido