Bosch JSH180 Instrucciones De Funcionamiento Y Seguridad página 15

2610051978.qxp_JSH180 3/16/20 8:33 AM Page 15
Service
Preventive maintenance performed by
un au thorized personnel may result in
misplacing of internal wires and
components which could cause serious
hazard. We recom mend that all tool
service be performed by a Bosch
Factory Service Center or Authorized
Bosch Service Station. SERVICE MEN:
Disconnect tool and/or charger from
power source before servicing.
Batteries
Be alert for battery packs that are
nearing their end of life. If you notice
decreased
significantly shorter running time
between charges then it is time to
replace the battery pack. Failure to do
so can cause the tool to operate
improperly or damage the charger.
Tool Lubrication
Your Bosch tool has been properly
lubricated and is ready for use.
Motors
The motor in your tool has been
engineered
dependable service. To maintain peak
efficiency of the motor, we recommend
it be examined every six months. Only a
genuine Bosch replacement motor
specially designed for your tool should
be used.
Maintenance
To avoid accidents, always disconnect the battery pack from tool
before servicing or cleaning.
NO USER SERVICE -
ABLE PARTS INSIDE.
tool performance
for many hours
Bearings
Bearings which become noisy (due to
heavy load or very abrasive material
cutting) should be replaced at once to
avoid overheating and motor failure.
Cleaning
damage plastic parts. Some of these
are: gasoline, car bon tetrachloride,
chlorinated cleaning solvents, ammonia
and household detergents that contain
ammonia.
Ventilation openings and switch levers
must be kept clean and free of foreign
matter. Do not attempt to clean by
or
inserting pointed objects through
opening.
CLEANING BLADE HOLDER
Clean the saw blade holder regularly.
For this, remove the saw blade from the
tool and lightly tap footplate on a level
surface.
Regularly spray penetrating oil onto the
saw blade holder.
Check the guide roller regularly. If worn,
it must be replaced through an
authorized Bosch Factory Service
Center
Lubricate the guide roller occasionally
of
with a drop of oil.
-15-
Certain cleaning
agents and solvents