Setting The Signal Type - Silvercrest STK 16 B3 Instrucciones De Montaje, De Uso Y De Seguridad

Synchronise the transmitter and receiver as follows:
As soon as the batteries are installed, the receiver enters synchro-
nizing mode for approx. 1 minute. During the synchronizing
mode, the signal indicator
You can also manually enter synchronising mode by holding the
synchronising button
The signal indicator
approx. 1 minute, to indicate that the receiver is in synchronizing
mode.
Press the chime button
in synchronise mode. If the receiver receives the signal, the steady
blue light of the signal indicator
that the synchronization is successful.

Setting the signal type

The receiver can indicate the reception of a door signal either both
optically and acoustically, acoustically or optically.
Using the signal type selector button
signal is to be indicated both optically and acoustically or acous-
tically or optically.
Press the signal type selector button
signal will sound up and the afterwards the signal indicator
will flash. The receiver will now indicate the door signal acousti-
cally and optically. Press again the signal type selector button
An acoustical signal will sound. The receiver will now indicate the
steadily lights up in blue color.
1
for approx. 3 seconds.
5
on the receiver will steadily light up for
1
of the transmitter, while the receiver is
9
flickers 6 times to indicate
1
, select whether the
3
once. An acoustical
3
1
.
3
GB/MT 65