Manual Motor Starter / Circuit Breaker - Installation instructions
The Bulletin 140 meets the requirements of IEC 947-2 as a circuit breaker. This device, however does
not meet UL and CSA circuit breaker requirements. The Bulletin 140 is UL listed (UL508) and CSA
certified as a Manual Motor Controller and is rated for Group Motor Installation. All installations,
commissioning and maintenance must be carried out by qualified personnel,taking local regulations
into account.
Leistungsschalter - Montageanleitung
Alle Montage-, Inbetriebnahme- und Wartungsarbeiten müssen durch Fachpersonal, unter
Berücksichtigung der örtlichen Vorschriften, ausgeführt werden.
Disjoncteur - Instructions de montage
Tous les travaux de montage, de mise en service et de maintenance ne doivent être exécutés
que par du personnel spécialisé en respectant les prescriptions locales.
Interruttore automatico - Instruzioni per il montaggio
Tutti i lavori di montaggio, messa in funzione e manutenzione devono essere eseguiti da
personale specializzato, conformemente alle norme vigenti localmente.
Interruptor automático - Instrucciones de montaje
Todos los trabajos de montaje, de puesta en servicio y de mantenimiento deberán ser
efectuados por personal especializado, considerando las prescripciones locales.
140M-KSF4
140
140M-KSFS
105
35
105.3
81
23.5
140-MN
L1
L2
L3
1
3
5
max. 70 mm 2
1, 3, 5
2, 4, 6
max. 95 mm 2
2
4
6
No. 8...3/0 AWG
T1
T2
T3
140M-M5F4
140
140M-M5FS
105
35
140-CL2/140-LD
max. 120 mm 2
4 Nm
max. 150 mm 2
35 Ib-in
300 MCM
140M-K5F
140M-M5F
140M-P5F
140M-P5F4
183.5
140M-P5FS
140
43.5
140-L2
max. 185 mm 2
16 Nm
max. 240 mm 2
145 Ib-in
500 MCM
126.1
98.3
40
16 Nm
145 Ib-in