8
EN
requires pulling until you hear the engine start to
tick over; no effort is required to pull the rope as
it does not create any resistance.
IMPORTANT
starter rope, do not pull the whole length of it or
let it slide along the edge of the cable guide hole.
Release the starter gradually, to avoid letting it fly
back uncontrollably.
6. Gradually release the handle (4) on the starter
wire to avoid it from returning too fast and out
of control.
7. Turn the starter control lever (3) to the «RUN»
position.
NOTE
tomatically return to the «RUN» position as soon
as the accelerator lever (5) is activated.
8. Allow the engine to run at minimum speed for
at least one minute before accelerating to
maximum speed.
IMPORTANT
starter wire is pulled repeatedly with the starter
control lever (3) in the «START» position it can
flood the engine and make starting difficult.
If you have flooded the engine, remove the spark
plug and gently pull the handle (5) on the starter
wire to eliminate any excess fuel; then dry the
spark plug electrodes and replace it on the
engine.
• Hot starting
When hot starting (immediately after stopping
the engine), follow the procedure indicated
above in points 1 - 4 - 5 - 6.
USE OF THE ENGINE (Fig. 3)
The speed of the cutting device is regulated by
the accelerater lever (1) positioned on the rear
To
avoid
breaking
The starter lever (3) will au-
If the handle (4) on the
HOW TO START - USE - STOP THE ENGINE
handgrip (2).
It is only possible to use this lever if the safety
lever (3) is pressed simultaneously.
The movement is transmitted from the engine to
the
the blade by a centrifugal mass clutch that pre-
vents the blade from moving when the engine is
running at minimum speed.
WARNING!
the cutting device moves when the engine is
running idle; in this case, contact you dealer.
The correct running speed will be achieved by
pressing the accelerator lever (1) as far as possi-
ble.
IMPORTANT
full power for the first 6-8 working hours.
STOPPING THE ENGINE (Fig. 4)
To stop the engine:
– Release the accelerator lever (1) and allow the
engine to run at minimum speed for a few sec-
onds.
– Press the (2) switch to the «O» position.
WARNING!
ing over, it will take a few seconds for the
blades to stop.
Do not use the machine if
Avoid using the engine at
When the engine is tick-