Trilux Belviso S EDS Serie Instrucciones De Montaje página 15

General features
Button
short
long
darker
Switch the luminaire on/off:
1. Shortly press the button once
By briefly pressing the button, the luminaire is switched on or
off.
Modifying the brightness
With switched-off lighting:
1. Press the button.
Hold the butten until the desired brightness is reached.
The lumimaire switches on at the minimum brightness level.
Continuosly pressing the button increases the brightness of
the luminaire. After the button is released, the light intensity of
the luminaire remains constant.
With switched-on lighting:
1. Press the button.
Hold the butten until the desired brightness is reached.
Modifying brightness. After releasing the push button, inten
sity of the luminaire remains constant.
28
short
off
long short
off
lighter
Switch between brightness increase and decrease:
2. Release the button and press it again.
Hold the butten until the desired brightness is reached.
Each renewed pressing and holding of the button effects a
change between light increase and light reduction.
Note:
Manual modification of brightness causes deactivation of
daylight dependent control. When switched on next this is
activated again.
Behaviour with mains power interruption
Following a mains interruption, the luminaire remains
switched off until presence is detected or a push button is
pressed.
Daylight-dependent control of brightness at the workstation
Automatic on/off switching of the luminaire
If sufficient brightness is available from daylight, the light
control device switches off the luminaire with a delay of
approx. 15 minutes. If the light level at the workstation falls
below the nominal value and people are present, the light
control device switches the luminaire on again and controls
the brightness.
29