Programming Ads - Fermax IP ADS Manual De Instalador

Interfaz IP ADS Interfaz IP ADS Interfaz IP ADS Interfaz IP ADS Interfaz IP ADS
Interfaz IP ADS Interfaz IP ADS Interfaz IP ADS Interfaz IP ADS Interfaz IP ADS
Programming the ADS
As one more terminal in the ADS installation, the ADS IP interface must be programmed
with a specific ADS address that identifies it in the installation, that is, it must be assigned
a call button (on pushbutton panels) or a numerical code (on panels with keypads).
Note: On City pushbutton panels, each button corresponds to an ADS address, determined by the
position of the extension pack to which the button is connected.
If it is installed together with one or more monitors in the same home/office, all the terminals
must be programmed with the same ADS address. In this way, when a call is made to that
home/office, all the monitors and the interface will receive the call.
The IP Interface's ADS address can be programmed via software, using a connected PC
with access to the interface (same type of IP address) or via hardware, from the outdoor
panel.
Programming via Software:
1.- Open an Internet browser and enter the interface's IP address (in this case, once the
IP address has been configured following the steps indicated in the previous section,
you will enter this address: http://172.30.111.34).
A screen appears, asking for the username and password:
Page 20