Working With The Blender - Silvercrest SKV 1200 B2 Instrucciones De Uso

Working with the blender

WARNING! RISK oF INjURy!
► Always allow hot fluids to cool down to a
lukewarm temperature (approx . 30–40°C)
before adding them into the blender t .
WARNING! RISK oF INjURy FRoM
SHARP BLADES/RoTATING DRIVE
UNIT!
► Never put your hand into the attached
blender t!
► Do not remove the blender t unless the
blades z are stationary .
► Operate the blender t only when the blender
lid r with the measuring cup e are attached .
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket
to prevent the appliance from being switched
back on unintentionally .
AttENtION! PrOPErty dAmAgE!
► Never use the mixing bowl 6 and blender t
at the same time! This will overload the motor!
► When working with the blender t we recom-
mend allowing the appliance to cool down
after 3 minutes of operation .
Proceed as follows to prepare the blender for
operation t . Use figure C on the rear fold-out
page as a guide .
1) Press down the release lever 2 and press the
swivel arm 1 downwards into the working
position .
2) Turn the drive protection cover u clockwise so
that the arrow on the drive protection cover u
is pointing to the
Remove the drive protection cover u and
place it to one side .
WARNING! RISK oF INjURy!
► Ensure that the rotary switch 3 is turned to
"0" before you place the blender t on the
blender drive i . Otherwise the appliance will
start immediately as soon as the blender t
has locked into place .
SKV 1200 B2
symbol on the appliance .
3) Place the blender t on the blender drive unit
i so that the lock tabs on the underside of
the blender t lock into the recesses on the
blender drive unit i . The
blender t must be pointing to the
on the appliance . Turn the blender t anti-
clockwise as far as it will go . The
on the blender t must then be pointing to the
symbol on the appliance .
4) Remove the blender lid r by turning it anti-
clockwise until it disengages from the catch on
the blender t and then pull it upwards and
off .
5) Add the ingredients .
6) Press the blender lid r with the measuring cup e
slightly offset firmly back onto the blender t .
Close the blender lid r by turning it clockwise
as far as the stop back into the catch on the
blender t . Ensure that the pouring spout on
the blender t is closed .
7) Turn the rotary switch 3 to the desired setting .
NOtE
► The ideal speed depends on the consistency
of the items being mixed . The more liquid the
contents are, the faster you can mix them .
► For short, powerful pulsed operation, turn
the rotary switch 3 anticlockwise to level P .
Level P does not lock into place so as not
to overload the motor . You should therefore
keep the rotary switch 3 in this position only
for a short time .
cruSHINg IcE
► In order to produce crushed ice, place ice
cubes in the blender t, close it and turn the
rotary switch 3 approx . 7 times to level P
for 5 seconds . You may need to adapt the
above instructions depending on the quantity
and size of the ice cubes .
symbol on the
symbol
symbol
GB │ IE 23 ■
│