Fimar MSD300P Manual De Uso página 28

MCD300-400-450-444C-554C-755C-776C:
2) Ignition switch
Press the ignition switch on the side of the machine
to feed the control panel.
2) ON-OFF push-button
The ON-OFF push-button ignites the display on the
control panel.
3) SET push-button
The machine provides n°6 programmes. By pressing
the SET push-button once, it is possible to access
and modify the settings of each program. By
successively pressing the SET push-button a red
hyphen light will appear and place itself alongside
these three options:
- VACUUM (suction time - from 1 to 60);
- SEAL (sealing time - from 0 to 10);
- GAS (aggregate gas delivery time - from 1 to 30)
4) Push-buttons + and –
After pressing the SET push-button a red hyphen will
appear and position itself over the various writings
so that the settings can be modified. The + and –
push-buttons allow the desired length of time to be
selected. After having chosen the level of time of an
operation press the SET push-button once more to
pass onto the next operation.
5) GAS LED
After pressing the SET push-button at the beginning
of each programme it is possible, by way of the Gas
ON and Gas OFF push-buttons, to start (the LED is
on) or end (the LED is off) the cycle of aggregate
gas delivery.
6) START-Force
- If this push-button is pressed down while the
chamber cover is open, it starts-up the pump so
that it pre-heats in the morning. By pressing the
push-button again, the pump is turned-off.
- By pressing the push-button when the
chamber cover is closed, it starts the quick
sealing process, and stops the process when
the cover is opened.
- By pressing the push-button twice while the
chamber cover is closed, it immediately stops
and opens the cover.
USE AND CLEANING
MCD444C
MCD554C
MCD755C
MCD776C
1
2
4
INFORMATION
1
5
4 3
3
MCD300
MCD400
MCD450
6