Recycling And Disposal - Venta COMFORT PLUS LW15 Manual De Instrucciones

ACCESSORIES
∙
Venta hygiene additive for flawlessly hygienic continuous operation
∙
Venta Cleaner for six-monthly cleaning
∙
Stimulating scents for every season and any mood
∙
Venta roller cart for a mobile Venta Airwasher (only for LW25 and
LW45 ComfortPlus)
∙
Venta thermo hygrometer for the monitoring of your ideal indoor climate
in the individual rooms
WARRANT Y
Due to the high quality of the product, the Venta-Luftwäscher GmbH guarantees
that this product when used properly will not be defective for a duration of two
years from the purchase date. If a material or processing error should occur any-
way, please contact the VENTA service team or your dealer. Venta's general war-
ranty conditions also apply: www.venta-luftwaescher.de/service/garantie/

RECYCLING AND DISPOSAL

The packaging material is re-usable. Please dispose of the packaging

in an environmentally friendly way and bring it to a collection centre for
recyclable materials.
The device may not be disposed of in normal household waste! It must be
disposed of at a selected collection point for the recycling of electric and
electronic devices (WEEE). Please use the local return and collecting sys-
tems that are available to you. By doing so, you are making a valuable
contribution to environmental protection and human health. For additional infor-
mation, please contact the local authorities.
VENTA-SERVICE-TEAM
Do you need additional information about the Venta Airwasher or do you want to
order accessories? No problem: the VENTA service team will take care of it! Call
the team directly or visit the Venta website.
DE +49 751 5008 88, www.venta-luftwaescher.de
28 EN
WHAT HAPPENS IF...?
!
Ensure that the device is switched off during any measures and the
switching power supply is disconnected from the outlet!
... E1 is shown in the display?
The device has switched off automatically because the locking buttons on the
upper housing are not closed properly.
Close upper housing properly again by pushing on the outer ends of lo-
i
cking buttons. Switch device off and on with the power button  .
... E2 is shown in the display?
The device has switched off automatically, because the motor is overstrained
(e.g. through the intrusion of foreign objects or similar).
Measure: Remove upper housing. Check whether the disk stack in the lo-
i
wer housing as well as fan blades in the upper housing are freely movable.
Next, place the device back in operation.
... the display is touched with stronger pressure?
This can result in visible „pressure points", which does not represent a quality
defect. After the pressure is removed, these „pressure points" will disappear.
... the power button  to switch on the device does not appear in the display?
Please check whether the switching power supply is connected to the mains.
... the power button  to switch on the device does not appear in the display,
even though the switching power supply is connected to the mains?
Please check whether the switching power supply is firmly plugged into the
drive unit
Measure: Remove upper housing. Check correct seating (see instructions
i
to clean the upper housing of the device). Next, place the device back in
operation.
... WATER is shown in the display, even though there is water in the lower
housing?
Please check whether there is sufficient water in the lower housing and/or
whether the upper housing is placed correctly on the lower housing.
Measure: Remove upper housing. Fill lower housing with tap water to
i
the WATERLINE marking. Place upper housing correctly on lower housing.
The switching power supply may not be jammed between the upper and
lower housings. Next, place the device back in operation.
EN 29