Foster S4000 Manual De Instrucciones página 26

Remaining heat indicator
Operating the timer
Glass ceramic hob also features remaining heat indicator "H". Hotplates are not
heated directly, but through return heat radiating from the dish. As long as the
symbol "H" is on after the hotplate was switched off, the remaining heat may be
used for warming up food or for melting. Even when the symbol "H" disappears,
the hotplate may still be hot. Be careful of burns!
The timer value can be selected between 1 and 99 minutes, and can be modified
at any time.
Initial default setting of the timer
The hob must turn on.
If the timer is off, it is activated by pressing one of its two keys (E+ o E-).
Heater on timer
The user can select the heater on which the timer function is to operate. The
timer can only operate on one heater each time.
The heater must always be selected (the display must be viewed "0") before the
time is set; otherwise, the timer will switch off.
If we take longer than 10 seconds to select the heater, the timer will switch off.
If, after selecting the heater, the time is not defined (T=00) in 5 sec., the timer
switches off.
When the timer value runs out, the heater associated with the timer switches off.
Indication of the heater on timer
The touch control indicates the heater on which the timer is operating. This
indication consists of a LED next to the heater display.
This option reminds the user at all times that the heater is on timer.
Increasing the value of the timer
If the sensor (+) or (-) associated with the timer is held down, The value
increases/decreases automatically. This makes it possible to reach the desired
timer setting more quickly. From the tenth consecutive increase/decrease of the
timer setting, the speed at which the value changes increases.
Timer Countdown End
The countdown begins 5 seconds after the last operation on the keys (+ and -) of
the timer (E). You will hear an acoustic signal, and timer's display and the LED of
the zone where you have activated the timer stop flashing.
The last minute will be displayed in seconds.
Switching the timer off
To cancel the operation of the timer, select a timer value of <00> using the
sensor (-), or switch off the timer by pressing the corresponding sensors (E+ and
E-).
Duration of the alarm
When the time set on the timer has run out, a beep sounds for 1 minute. After 1
minute from when the timer alarm starts, the beep stops. The timer displays
continue to flash with the indication <00>. The alarm can be cancelled by the
user at any time, even during the first minute of the alarm, by pressing any
sensor on the touch control.
ATTENTION: The timer can also be set up for a cooking zone that is at the
level "0", LED will remain flashing all the time of the countdown. In this
case the timer can have alarm function.
26