Installation Diagram; Power Management - Foster S4000 Manual De Instrucciones

Installation diagram

Power Management

Power management for a
Limited Power Cooktop
(ECO)
ATTENTION !
Before attempting any repairs on the appliance, disconnect the power supply. In
accordance with the mains voltage the appliance should be connected in line
with the attached diagram.
The earthing wire (PE) must be connected to the terminal marked with the
earthing symbol .
The connection cable must lead through the relief safety device, protecting it
from accidental pulling out. Upon the completion of installation switch all the
hotplates on for about 3 minutes to check the proper functioning.
Connection must be carried out by means of harmonized cables as H05V2V2-F
(90°C), or with equal or better features.
In cases where the cooktop is already in operation for some time, to change the
limit of power, before proceeding with the planning, unplug it, then reinsert the
plug after a couple of minutes.
The power drawn is 2800 W, but you can increase it at 3500 W, 6000 W or
7200W.
The sequence to set a new Cooktop Power Limit is:
▪ During the first 30 seconds after plugging the appliance
▪ The Touch has to be unlocked and all Heaters Off
▪ Push at the same time (A+,A-,D-,D+) keys
▪ Once this is done, a beep sounds and "Po" Characters will be in the timer
display and the "actual Cooktop Power Limit" will be in the display 1 and in the
display 4.
For selecting a new Power Limit:
▪ With any Heater (+ or -) key, the Power Limit is increased/decreased. The
selectable powers are: 2800 W, 3500 W, 6000 W or 7200W.
The sequence to finish recording the new Cooktop Power Limit is :
▪ Push at the same time (A+,A-,D-,D+) keys.
▪ Once this is done, new Cooktop Power Limit is recorded and there is a system
reset.
To finish without recording changes:
▪ If during 60 seconds there is no action, changes are not recorded and there is
a system reset
21