Foster S4000 Manual De Instrucciones página 28

Induction
plate
Ø (mm)
Level
0
1
2
3
4
5
6
7
8
9
P
Safety functions and error display.
ERROR CODE
r
u
H
c
C
FA
FC
FE
FT
Fc
FH
FJ
FO
FL
FU
1 2 3
210 145 210
Power (W)
0 0 0
100 75 100
200 150 200
300 300 300
500 400 500
700 500 700
900 600 900
1100 800 1100
1300 1000 1300
1500 1200 1500
2000 1600 2000
ERROR DESCRIPTION
See "Power management for a limited
power cooking hob (ECO)" pag.28
1) See "Pan sensor" pag.24-25
2) Overvoltage disturbance
See "Displaying power levels" pag.27
Induction generator overtemperature
Induction heater overtemperature
Anomaly of infrared signal, of on/off key -
all cooking zones are deactivated
Receiver infrared anomaly of button
on/off - all cooking zones are deactivated
Touch control ntc sensor: short circuit on
ntc sensor.- all cooking zones are
deactivated
Touch control ntc sensor: ntc sensor
opening - all cooking zones are
deactivated
Touch control ntc sensor: ntc sensor
overheating - all cooking zones are
deactivated
Eprom (memory) of Touch control:
anomaly of touch control eprom. - All
cooking zones are deactivated
Anomaly of adc, of on/off key - all
cooking zones are deactivated
Touch Control Sotware: anomaly on the
touch control software. - All cooking
zones are deactivated
Touch Control luminosity: excessive
external luminosity that hampers t/c
sensors (push buttons) calibration - All
cooking zones are deactivated
Touch Control Divider: anomaly on the
t/c Divider. - All cooking zones are
deactivated
4
145
0
75
150
300
400
500
600
800
1000
1200
1600
Contact authorized center for technical
assistance - specifying the error code
Switch the hob off and the oven installed
underneat it until they cool down
completely. Turn on the hob to check all
functions. If the problem remains Contact
authorized center for technical assistance -
specify the error code
Switch the hob off and the oven installed
underneat it until they cool down
completely. Turn on the hob to check all
functions. If the problem remains Contact
authorized center for technical assistance -
specify the error code
Contact authorized center for technical
assistance - specifying the error code
Contact authorized center for technical
assistance - specifying the error code
Contact authorized center for technical
assistance - specifying the error code
Contact authorized center for technical
assistance - specifying the error code
Switch the hob off and in case also the
underbuilt-in ofen since completely
cooling. Turn on the hob to check all
functions. If the problem remains contact
authorized center for technical
assistance - specifying the error code
Contact authorized center for technical
assistance - specifying the error code
Contact authorized center for technical
assistance - specifying the error code
Contact authorized center for technical
assistance - specifying the error code
Remove or replace the external
luminosity source. If the problem remains
despite the calibration conditions have
been respected : contact authorized
center for technical assistance -
specifying the error code
Contact authorized center for technical
assistance - specifying the error code
INSTRUCTION MANUAL
28