LG LDE4415ST Manual Del Propietário página 38

38 MAINTENANCE
When to Use EasyClean®
EasyClean®
Self Clean*
_!i! ¸_¸_¸_i_;¸!¸i¸¸¸¸i¸¸¸ ¸¸_¸¸¸ ¸¸¸ ii_i_ iiii iii_ ¸¸¸¸¸'•''" "•••
Small drops or
spots
Light splatter
Medium to
heavy splatter
Drops or spots
Cheese
or other
ingredients
Fat/grease
Fat/grease
Filling or
sugar based
soils
Cream or
tomato
sauce
Pizza
Steaks, broiled
Fish, broiled
Meat roasted at tow
temperatures
Meat roasted at high
temperatures
Pies
Casseroles
* The Self Clean cycle can be used for soil that has been built up over time.
Cleaning Tips
• Allow the oven to cool to room temperature before
using the EasyClean® cycle. If your oven cavity is
above 150 °F (65 °C), Hot will appear in the display,
and the EasyClean® cycle wilt not be activated until
the oven cavity cools down.
A plastic spatula can be used as a scraper to
scrape off any chunks or debris before and during
oven cleaning.
Using the rough side of a non-scratch scouring pad
may help to take off burnt-on stains better than a
soft sponge or towel.
Certain non-scratch scrubbing sponges, such as
those made of melamine foam, available at your
local stores, can also help improve cleaning.
The range should be level to ensure that the bottom
surface of the oven cavity is entirely covered by
water at the beginning of the EasyCtean® cycle.
For best results, use distilled or filtered water. Tap
water may leave mineral deposits on the oven
bottom.
Soil baked on through several cooking cycles will
be more difficult to remove with the EasyClean®
cycle.
Do not open the oven door during the EasyCtean®
cycle. Water will not get hot enough if the door is
opened during the cycle.
For hard to reach areas such as the back surface
of the lower oven, it is better to use the Self Clean
cycle.
EasyClean ® instruction Guide
1 Remove oven racks and accessories from the
oven.
2 Scrape off and remove any burnt-on debris with
a plastic scraper.
Suggested plastic scrapers:
Hard plastic spatula
Plastic pan scraper
Plastic paint scraper
Old credit card
3
Fill a spray bottle with 1¼ cups (10 oz or 300 mt)
of water and use the spray bottle to thoroughly
spray the inside surfaces of the oven.
4 Use at least ¼ cup (2 oz or 60 mt) of the water
to completely saturate the soil on both the walls
and in the corners of the oven.