Parameter Table - LOVATO ELECTRIC DMED310T2 Manual De Instrucciones

1 - Bar graph of the setting-range
2 - Minimum possible setting
3 - Selected parameter
M01 - GENERAL
P01.01 CT primary
P01.02 CT secondary
P01.03 Nominal voltage
P01.04 Nominal power
P01.05 Wiring
M02 - UTILITY
P02.01 Language
P02.02 Display contrast
P02.03 High backlight level
P02.04 Low backlight level
P02.05 Low backlight delay
P02.06 Default page return
P02.07 Default page
P02.08 Default sub-page
P02.09 Display update time
P02.10 Shortcut command
– If the Advanced level access code has not been entered, it will not be possible to enter editing page and an access denied message will be shown.
– If instead the access rights are confirmed, then the editing screen will be shown.
– When the editing screen is displayed, the parameter setting can be modified with L M keys. The screen shows the new setting, a bar graph that shows the
setting range, the maximum and minimum values, the previous setting and the factory default.
– Simultaneously pressing L and M, the setting is set to factory default.
– During the entry of a text string, keys L and M are used to select the alphanumeric character while
Pressing keys L and M simultaneously will move the character selection straight to 'A'.
– Press to go back to the parameter selection. The entered value is stored.
– Simultaneously press keys L and M to save all the settings and to quit the setup menu. The multimeter executes a reset and returns to normal operation.
– If the user does not press any key for more than 2 minutes, the multimeter leaves the setup automatically and goes back to normal viewing.

PARAMETER TABLE

P01.01 = CT primary winding rated current.
P01.02 = CT secondary winding rated current. For DMED310T2 fixed to 5A.
P01.05 = Set this parameter according to the used wiring diagram.
See wiring diagrams on page 15.
P02.06 = If set to OFF, the display always remains at the page where the user left it. If set to a time delay and after that time, the display page goes back to page
set in P02.07.
P02.07 = Number of the page to which the display automatically returns after time specified by P02.06 has elapsed from the last keystroke.
P02.08 = Sub-page type to which the display returns after P02.06 has elapsed.
P02.10 = Allows you to execute a command by pressing key
is used to move the cursor along the text string.
UdM
A
A
V
kW
UdM
%
%
%
sec
sec
sec
for 5 seconds. Refer to COMMANDS MENU section.
4 - New value entered
5 - Maximum possible setting
6 - Factory default setting
Default Range
5 5-10000
5 5
AUT AUT /
220 – 415
AUT AUT /
1 - 10000
L1-L2-L3-N L1-L2-L3-N
L1-L2-L3
L1-N-L2
L1-N
Default Range
English English
Italiano
Francais
Espanol
Portoguese
50 0-100
100 0-100
30 0-50
30 5-600
60 OFF / 10-600
Energy-power (page list)
IN / IMP / TOT IN / IMP / TOT
HI / EXP / PAR
LO
AV
MD
GR
1- 4
0.5 0.1 - 5.0
OFF C01-C02-C03-C04-
C05-C06-C08
G
B
9