Connecting The Auxiliary Power Supply - Bosch BPT-C 200 Instrucciones De Servicio

English
CAUTION
Bosch Power Tec GmbH
5. Label the cables
Risk of injury due to damaged cable strain relief
Connection cables that are not strain-relieved may become damaged or
severed. This can result in serious personal injury or material damage.
 Fit the cable strain relief on-site
 Use cable strain relief (cable support rail) to adequately secure
connection cables that enter the device
Only use aluminium or plastic cable clips for the cable strain relief. Check

all cable leads before connecting the cabling
6. Secure the cables on cable support rails
7. Fit the protective cover and screw into place
■
The grid is connected.
5.6

Connecting the auxiliary power supply

Materials required
Single-phase cable, 230 V, 50 Hz

Prerequisites
 Ensure that the auxiliary power supply cables are fully de-energised
 TN grid
 Series fuse 16 A, type B or similar available
 If there is no auxiliary power supply (230 V
isolated transformer with 2.5 kVA output to supply the central inverter
with 230 V.
Installation | 57
), use a separate galvanically
AC
BPT-C 200, 300, 350 | Operating manual