TRAPP DM 50 Manual De Instrucciones página 41

www.trapp.com.br
Attention!
Before making any connections, make sure power source is disconnected.
1. Make sure the power source where the equipment will be installed is compatible with the data shown
on the motor plate.
2. Disconnect the power source to make motor connections.
3. Make the connections shown according to the voltage of the power source.
4. Make sure the connections are well insulated.
5. Turn on power source and check the rotation of the equipment.
6. For your safety, ground the equipment and hire a qualified electrician.
Gasoline
Certify that there'-s oil in the crankcase and if the

level is correct. The factory engines use 20W50 oil.
Check for the presence of gasoline in the fuel tank.

Check the gasoline tank capacity and the amount of

crankcase oil on page 37.
5
4
3
2
Image merely illustrative
After refueling with gasoline and adding oil to the

crankcase, turn the power cut-off switch (1) on, open
the fuel valve (3), place the choke lever (4) and the
throttle lever (5) towards the rabbit direction.
1
1
Carefully pull the retractable (2) start rope until you

find some resistance, then pull it all the way through.
Repeat this procedure until the engine runs.

Release the rewind starter rope gently to avoid

damaging the engine's covers.
Allow the motor to heat up for some minutes.

Return the choke lever (4), when returning the choke

lever to the original position, if the engine does not
turn off, this indicates the engine is warmed up.
Activate the throttle lever and start working with the

maximum rotation.
In an emergency situation, in order to turn the engine

off turn the power cut-off switch (1) off. Under
normal conditions, to turn the engine off, close the
fuel valve (3) and let the engine turns off due to lack
of fuel in the carburetor, then, turn the power cut-off
switch (1) off.
Note: for further information on the operation, refer to
the motor manual.
41