Bushnell EQUINOX Z 260500 Guia De Inicio Rapido página 9

(The following items are located on the bottom of the unit, under the Interface Cover Flap (N))
PHOTO/VIDEO SWITCH (J)
The Photo/Video slide switch under the Interface cover flap determines whether still photos or videos are captured when
using Record.
• Set the switch to the "Photo" position to select still photo recording mode when the Record button is pressed .
• Set the switch to the "Video" position to select video recording mode when the Record button is pressed .
MICRO SD CARD SLOT (I): a micro SD card (user supplied, up to 32GB maximum) must be inserted before it is possible to use the
Record function. If a card is not inserted, the message "No Card !" will be seen on the display when the unit is turned on.
USB PORT (H): connect a USB cable between this port and a PC/Mac to download photos/videos without removing the card. The
Equinox Z is USB mass storage compliant.
VIDEO OUTPUT ("TV OUT") JACK (G): the "live" image as seen on the unit's display is output here. Connect the included video cable
(1/8" to RCA) between this jack and a video monitor or recorder to remotely view or record the image from the night vision unit.
SETUP AND BASIC OPERATION
1) LoaD BattErIES
Rotate the IR Light barrel (D) in the indicated "unlock" direction to unscrew and remove it, and insert 4 AA batteries as indicated
inside the battery compartment (O). Line up the IR Light barrel (indentation at the top) and screw it back in place ("lock" direction),
being careful to keep it parallel to the binocular body to avoid cross-threading. Lithium AA batteries are recommended for maximum
running time, but alkaline or rechargeable NiMh AAs may be used as well. DO NOT MIX BATTERY TYPES, OR NEW AND OLD BATTERIES.
Remove the batteries if the unit will be stored for a month or longer between uses.
2) rEMoVE LENS coVEr, aDJuSt DISpLaY (EYEpIEcE) FocuS For Your VISIoN
Press the Power button (A) to turn on the unit. A battery level icon is displayed at the top right corner of the screen. While looking
through the eyepieces (M) at the LCD displays, rotate each eyepiece (eyecup) until the display icons or edges of each display screen
appear sharp to your eye. Adjust the eyepiece spacing (IPD) to your eye width using the IPD adjust knob (P) or by sliding the eyepieces
closer together or farther apart. Remove the lens cover from the front of the objective lens (K). Note: since the Equinox Z uses digital
9