Location And Functions Of Parts And Controls - Sony SNC-Z20N Manual De Instalación

Location and
Functions of Parts
and Controls
Front
1 2 6
3 4
1 Lens
A × 18 optical zoom, auto-focus lens is
mounted as standard equipment.
2 NETWORK indicator (orange/
green)
The indicator flashes in orange when the
camera is connected to the 10BASE-T
network; it flashes in green when the
camera is connected to the 100BASE-
TX network.
The indicator goes off when the camera
is not connected to the network.
3 PC card lever
Press the lever to remove the PC card
from the camera.
4 PC card slot
Insert the recommended ATA memory
card ("Memory Stick" in the PC card
adaptor) into each slot.
7
5

Location and Functions of Parts and Controls

Note
Insert the PC card with its front side (B
mark) downward. Make sure that the PC
card is fully pushed in.
B
mark
5 Lid
Pull to remove the lid. To replace, push
it in fully to the end.
6 POWER indicator (green)
When the power is supplied to the
camera, the camera starts checking the
system. If the system is normal, this
indicator lights up.
If a system error occurs, this indicator
flashes every second. In this case,
consult your authorized Sony dealer.
7 Tripod adapter
Use this adapter when attaching the
camera to a tripod (screw: 1/4", 20
UNC)
The following mounting screw can be
used.
U1/4", 20 UNC
(ISO standard)
Caution
Use the mounting screw whose length is
4.5 mm ± 0.2 mm only. Use of other
= 4.5 mm ± 0.2 mm
7
GB