Assigning The Ip Address Using The Setup Program - Sony SNC-Z20N Manual De Instalación

Assigning the IP Address
Using the Setup Program
1
Insert the supplied CD-ROM
disc into your CD-ROM drive.
2
Double-click the Setup folder in
the CD-ROM drive.
3
Double-click Setup.exe.
4
Install the IP Setup Program to
your computer following the
wizard displayed.
If the Software License Agreement is
displayed, read it carefully and accept
the agreement to continue the
installation.
5
Start the IP Setup Program.
The program detects the SNC-Z20
cameras connected on the local network
and lists them on the Network tab
window.
6
Click on the camera you want to
assign a new IP address in the
list.
The network settings for the selected
camera are displayed.
12
GB
Assigning the IP Address to the Camera
7
Set the IP address.
To obtain the IP address
automatically from a DHCP
server:
Select Obtain an IP address
automatically.
The IP address, Subnet mask and
Default gateway are assigned
automatically.
To specify the IP address
manually:
Select Use the following IP address,
and type the IP address, Subnet mask
and Default gateway in each box.
8
Set the primary DNS Server
address and, if necessary,
secondary DNS server address.
To obtain the DNS server
addresses automatically:
Select Obtain DNS server
automatically.
To specify the DNS server
addresses manually:
Select Use the following DNS server,
and type the primary DNS server
address and Secondary DNS address in
each box.
Note
The Third DNS Server address and
Fourth DNS Server address are invalid
for this camera.
9
Set the HTTP port number.
Normally select 80 for the HTTP port
No. To use another port number, select
the text box and type a port number
between 1024 and 65535.
10
Type the Administrator name
and Administrator password.
The default settings of both items are
"admin."
11
Confirm that all items are
correctly set, then click OK.
If "Setting OK" is displayed, the IP
address is correctly assigned.