Side Hinge Door Alignment Procedure - Thermador ME301WS Guia De Instalacion

Side Hinge Door Alignment Procedure

Open the door to approximately 135°.
1.
Using a Torx T20 screwdriver, loosen the three screws
2.
(A) on the lower hinge by 1 to 2 full turns.
Note: All adjustments are made with the lower hinge
only. The upper hinge is fixed in place and cannot be
adjusted.
Using a #2 Phillips screwdriver, turn the cam screw
3.
(B) right or left to adjust the hinge position in the
desired direction.
Note: 1mm of hinge movement (left or right) will move
the door up or down approximately 1.5mm at the door
catch.
Re-tighten the screws before closing the door to test.
4.
Be careful not to overtighten.
Check for proper door alignment. Repeat adjustment
5.
procedure as necessary.
14