MRA 4025066154463 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
1 Pair of holding plates
4 Round head screws, M5 x 16 mm
4 Round head screws, M5 x 20 mm
4 Plastic washers, 12 x 5 mm
4 Rubber nuts, M5
4 Spacers, 3 mm
4 O-rings, black, 4.5 x 1.5 mm
1 Edge protector strip with end sleeves
How to mount the screen on your motorbike:
1. Stand your motorbike up on a level surface.
2. Dismantle the original screen.
3. Mount the brackets to your motorbike using the M5 x 16 mm Allen screws supplied.
The lugs on the brackets are different in length; mount each bracket with the
longer lug in the downward position and the shorter lug in the upward position (P1).
4. Place the rubber nuts supplied into the drilled holes on the brackets.
5. Place the M5 x 20 mm round head screws with the plastic washers into the holes in
your MRA screen. Place the spacers onto the screws from the inside. Tip: Place the
spacers first, then the O-rings supplied onto the screws; this will help you mount the
screen (P2).
6. Position our MRA screen on the brackets and tighten the screws.
7. Install the edge protector strip onto the screen as shown in P3. Place the end sleeves
over the end of the edge protector strip and gently squeeze the sleeves with a pair of
pliers to secure the edge protector strip.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
BMW S1000XR 2015-
Article No..
--- Torx TX 25 screwdriver
11089 3 mm Allen key
10554
10673
10635
10629
10872
10992
---
3
Required tools