General Operation; Front Panel/Controls - Smarter tools CUT-40 Manual Del Usuario

SECTION 4:
OPERATION

4.1 General Operation

Conventional operating procedures apply when using the Cutting Power Source,
i.e. connect work lead directly to work piece and torch is used to hold electrode.
Wide safety margins provided by the design ensure that the Cutting Power
Source will withstand short-term overload without adverse effects.

4.2 Front Panel/Controls

Familiarize yourself with the location and purpose of the controls on this unit
before attempting to operate.
A)
A) Gas Pressure Display
The built-in gas display is used for reading the output gas pressure
when cutting.
B) Power Indicator Light
This light will turn on when the input power cord is plugged into the
power supply and the power switch on the back of the plasma cutter is
in the "ON" position.
C) Work Indicator
When cutting, this light is on to show the unit is on working mode.
D) Protection Indicator Light
When the unit is in thermal overload, is over voltage or lacking voltage,
the indicator will be on and the machine will stop working. When the unit
B)
D)
4-1
C)
E)
F)