Back Panel/Power Switch - Smarter tools CUT-40 Manual Del Usuario

is cooled down and voltage stabilizes, the unit will return to work
automatically.
E) Low Air Pressure Indicator Light
This light will be on when the gas flow is low.
F) Cutting Current Adjustor
Variable adjust the output cutting current. The higher output matches
the thicker metal. The maximum cutting thickness is up to 3/8 " for this
unit. Please note that the maximum cutting thickness varies depending
on the material type you are cutting. See the following table for
reference.
Material
Carbon Steel
Aluminum
Stainless Steel
Copper

4.3 Back Panel/Power Switch

Familiarize yourself with the location of the "Back Panel" Power Switch before
attempting to operate. The "Back Panel" Power Switch controls the Mains Supply
Voltage to the Power Source.
4.3 Operating Instructions
•
Check the plasma cutter to see if it has been connected correctly and is
in good working condition as described in within this manual and that it
complies with safe operation requirements.
•
Switch on the power supply switch of the cutter to observe if the
operation is normal. If it is normal, the fan should start up and the Power
Supply Indicator Light should be on. If there is no compressed air or the
air pressure is low the Low Pressure Indicator Light will be on.
Maximum Cutting Thickness
3/8"
1/4"
1/4"
1/8"
ON
OFF
4-2