MRA 4025066141333 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
1 Edge protection strip
2 Clamp sleeve
4 Allen screw M 5 x 35mm
4 Plastic washer
4 Plastic spacer 10mm
4 Rubber washer 4mm
Fitting the windshield to the motorcycle:
1. Position the motorcycle on a level surface.
2. Disassemple the original windshield by removing the four screws with T25 Torx key.
3. Insert the four Allen screws with the plastic washers from the upper side into the
holes of the MRA windscreen.
Push the Plastic spacer and the rubber washer from the bottom on the screw. The
rubber washer only about 5mm.
4. Put the windshield on the original brackets and mount it by fixing the Allen screws
with the 3 mm Allen key.
5. Fit the edge protection strip on the whole rear end of the windshield (not on the
adjustable spoiler), and cut it symmetrically on the left and right side.
6. Slide the clamp sleeves over the ends of the edge protection strip and gently squeeze
them tight with the pliers, ensuring that the strip is clamped on the windshield.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
BMW R1150R
Article No..
--- Allen key 3mm
--- Torx 2
Gerneral-purpose pliers
---
10632
10635
10633
10634
3
Required tools