Ce Declaration Of Conformity - FAAC E012S Manual De Usuario

1. WARNINGS
2. LAYOUT AND CONNECTIONS
3. TECHNICAL SPECIFICATIONS
3.1. DESCRIPTION OF COMPONENTS
3.2. DESCRIPTION OF TERMINAL-BOARDS
4. PROGRAMMING THE LOGIC
5. PROGRAMMING THE SPEED
6. START-UP
6.1. LEDS CHECK
6.2. PROGRAMMING THE DIPS-SWITCH
6.3. PRE-FLASHING
6.4. TIME - SETUP LEARNING
7. INSTALLATION OF BUS ACCESSORIES
7.1. ADDRESSING THE BUS PHOTOCELLS
7.2. MEMORY STORAGE OF BUS ACCESSORIES
8 MEMORY STORING THE RADIO CODE
8.1 MEMORY STORAGE OF DS RADIO CONTROLS
8.2 MEMORY STORAGE OF SLH RADIO CONTROLS
8.3 MEMORY STORAGE OF RC/LC RADIO CONTROLS (for some markets only)
8.4 RADIO CONTROLS DELETION PROCEDURE
9. BATTERY KIT (OPZIONAL)
10. AUTOMATED SYSTEM TEST
11. LOGIC TABLES
Manufacturer: FAAC S.p.A.
Address: Via Benini, 1 - 40069 - Zola Predosa - BOLOGNA - ITALY
Control unit mod. E012S
Declares that:
• conforms to the essential safety requirements of the following EEC directives:
2006/95/EC Low Voltage directive.
•
• 2004/108/EC Electromagnetic Compatibility directive.
Additional information:
This product underwent a test in a typical uniform configuration (all products manufactured by FAAC S.p.A.).
Bologna, 27 November 2008
Read this installation manual to the full before you begin installing the product.
The symbol indicates notes that are important for the safety of persons and for the good condition of the
The symbol draws your attention to the notes on the characteristics and operation of the product.
INDEX

CE DECLARATION OF CONFORMITY

Notes on reading the instruction
automated system.
9
page.10
page.10
page.11
page.11
page.11
page.11
page.11
page.11
page.11
page.12
page.12
page.12
page.13
page.13
page.13
page.14
page.14
page.14
page.14
page.15
page.15
page.15
page.16
Managing Director
A. Marcellan