Automated System Test; Radio Controls Deletion Procedure - FAAC E012S Manual De Usuario

the selected channel.
5. The LED on the board relating to the channel being
learned flashes for 5 sec., within which time the code
of another radio control must be transmitted.
6. The LED lights up on steady beam for 2 seconds, indi-
cating memory storage executed, and then resumes
flashing for 5 sec., during which other radio controls
can be memory stored, and then goes OFF.
8.4 RADIO CONTROLS DELETION
PROCEDURE
1. To delete ALL the input radio control codes, press
push-button LOGIC (SW3) or SPEED (SW2) and, while
holding it down, also press push-button SETUP (SW1)
for 10 sec.
2. The LED relating to the pressed push-button flashes
for the first 5 sec, and then flashes more quickly for
the next 5 sec.
Both LEDs light up on steady beam for 2 sec and then
3.
go OFF (deletion completed).
4. Release both push-buttons.
This operation is NOT reversible. All codes of radio
controls stored as OPEN A and OPEN B will be
deleted.
9. BATTERY KIT (OPZIONAL)
The buffer battery kit was built for insertion inside the
control board support.
This support (Fig. 4 ref. ) was pre-moulded to permit the
battery housing to be opened.
1. Remove the board support material covering the
battery housing, cutting the material connections
along the perimeter.
2. Insert the battery in the housing you have just created,
and secure it on the anchoring supports (Fig. 5).
3. To correctly fasten and connect the kit to the con-
trol unit, consult the instructions enclosed with the
battery kit.

10. AUTOMATED SYSTEM TEST

When you have finished programming, check if the
system is operating correctly. In particular, check if the
safety devices are operating correctly.
Fig. 4 Fig. 4
Fig. 5 Fig. 5
15