Assembly; Installation Of The Loop Handle; Installation Of The Cutting Blade - Kawasaki KEL27B Manual Del Usuario

Assembly

Installation of the Loop Handle

Place handle assembly at positioning
label on the pipe assembly and tighten
the 4 bolts by using the screwdriver.
E
D
F
A. Bracket D. Pipe Assembly
B. Handle Assembly E. Bolts
C. Positioning Label F. Nuts

Installation of the Cutting Blade

Insert the Allen wrench (C) into the
●
hole at the side of the holder (A).
the holder (B) until the Allen wrench
●
slips into position and blocks the out-
put shaft (D).
Remove the nut (E) and holder (B)
●
from the output shaft by unscrewing
the nut clockwise (left-hand thread).
Align the hole (1 inch) of the cutting
●
blade (F) with the holder (A).
Fit the holder (B) and the nut at the
●
output shaft.
Tighten the nut by screwing it counter-
●
clockwise firmly.
Remove the Allen wrench from the
●
holder (A).
B
When fitting the holder (B) on the cut-
⃝
ting blade, make sure that there is no
space between the holder (A) and cut-
ting blade.
If the cutting blade is not installed prop-
⃝
erly. It may cause abnormal vibration.
C
A
F
B
E
A. Holder (A)
B. Holder (B)
C. Allen Wrench
NOTE
D
A
C
D. Output Shaft
E. Nut
F. Cutting Blade
9