Warming Up; Idling Speed; Fuel Adjustment - Kawasaki KEL27B Manual Del Usuario

16

Warming Up

After starting the engine, run the
●
engine at the idling speed (throttle
lever position is fully CLOSED) for a
few minutes.
CAUTION
Allow sufficient warm-up time to prevent
engine damage. The handheld edger
should be run at idling speed for 3 to 5
minutes to allow it to warmup before
applying a load. This will allow oil to
reach all engine parts, and allow piston
clearance to reach design specifica-
tions.
A
A. Throttle Lever
When restarting warmed engine
Set the enrichment lever to the "RUN-
NING" position and then pull the recoil
starter grip.

Idling Speed

If the cutting blade moves when the
●
engine is running at the idling speed,
turn the idling adjust screw counter-
clockwise to decrease the engine
idling speed.
If the engine does not run the idling
●
speed, it may be changed too low, turn
the idling adjust screw clockwise to
increase the engine idling speed. The
stable idling speed is about 3000 r/min
(rpm).

Fuel Adjustment

The carburetor has been adjusted to the
optimum fuel supply at the factory. Do
not reset the carburetor setting.
NOTE
If adjustment is needed, it should be
⃝
performed by you're authorized
Kawasaki dealer.
A
A. Idle Screw