Gear Case Lubrication Service; Catalytic Converter - Kawasaki KEL27B Manual Del Usuario

22
Never sharpen, straighten or weld the
cutting blade. It might shatter and cause
serious or fatal injury.
Replace the cutting blade with a new
one when a crack or warp is found or the
cutting edges are dull.
NOTE
Before replacing the old cutting blade
⃝
with the new one, check for, and remove
any debris built up in the guard. Then
after cleaning the inside of guard,
install new cutting blade. Debris build
up may cause the guard to crack or
break with new cutting blade.

Gear Case Lubrication Service

WARNING
Hot engine parts can cause severe
burns.
Allow engine to stop, and cool before
lubricating gear case.
Check and lubricate the gear case every
50 hours in use.
Remove the bolt.
●
Supply #1 class lithium grease into the
●
gear case by using container.
Install the bolt.
●
A
A. Gear case Assembly
B. Grease Container (Example)

Catalytic Converter

Catalytic Converter:
This small engine is equipped with a cat-
alytic converter in the exhaust system to
significantly reduce exhaust emissions.
The catalytic converter converts carbon
monoxide and hydrocarbons into harm-
less carbon dioxide and water.
The catalytic converter requires special
care.
Use only unleaded gasoline. Never
●
use leaded gasoline.
Leaded gasoline significantly reduces
the capability of the catalytic convert-
er.
Do not use 2-stroke oil that contains
●
Phosphorus (P), Lead (Pb), or Sulfur
(S). These elements will reduce the
B
life and performance of the catalytic
converter.
Before shutting the engine off, allow it
●
to idle for a short while.
Never stop the engine during operation
⃝
while running above idle speed.
NOTE