Dynex DX-E101 Manual De Uso página 9

Dynex5x7-multi.book Page 9 Friday, September 9, 2005 12:32 PM
Using the Network Setup Disk
3 Click the Support tab. The IP address is displayed.
4 Click Close.
Assigning a static IP address
Note: DHPC (Dynamic Host Configuration Protocol) is a communications
technology that automatically assigns IP addresses to computers on a network. If
you have a DHCP-capable router, you do not need to assign IP addresses to
computers on the network.
To assign a static IP address in Windows XP:
1 Click Start, then click Control Panel. The Control Panel window opens.
2 Click or double-click Network Connections.
3 Right-click Local Area Connections, then click Properties. The Local Area
Connections Properties dialog box opens.
9