MRA 4025066166015 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windscreen
1 Pair of retaining plates
4 Elastic nuts M5
8 Plastic discs 12x5x0.5mm
2 Lens head screws, M5x16mm
8 O-rings, 4.5x1.5
4 Lens head screws, M5x20mm
2 Lens head screws, M5x25mm
2 Distance sleeves 15mm
6 Distance sleeves 3mm
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Remove the original windscreen.
3. Insert the M5x25mm lens head screws [10641] with the plastic washers [10635] provided through
the upper (long) holes of the retaining plates [11366].
4. Place the 15mm distance sleeves [10636] against them from behind and secure these using the O-
rings supplied [10992].
5. Now, put the M5x16mm lens head screws [10554] with the plastic washers [10635] through the
lower holes of the retaining plates and place the 3mm distance sleeves [10872] against these from
behind. Secure these as well using the O-rings supplied [10992], like shown in figure 1.
6. Mount the retaining plates [11366] to the motorcycle and insert the M5 elastic nuts provided
[10629] into the bore holes as shown in figure 2.
7. Insert the M5x20mm lens head screws [10673] with the plastic washers [10635] through the bore
holes of the MRA windscreen. Place the 3mm distance sleeves [10872] against them from behind
and secure these using the O-rings [10992].
8. Now, mount the MRA windscreen to the motorcycle and tighten the screws firmly.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Tiger 1200/XC/XR 2016-
Article No..
--- Allen key 3 & 5mm
11366
10629
10635
10554
10992
10673
10641
10636
10872
2
Required tools