Useful Suggestions - TRAPP TRR 180 Manual De Instrucciones

www.trapp.com.br
Some problems may occur during the use of the shredder. Find some suggestions to solve them below:
Problem Probable Cause
Shredder Excessive intake/feeding. Organic
jamming material accumulates inside the
machine.
Low production
1. Insufficient feeding.
2. Machine
specification
3. Humid product.
Irregular cut 1. Cutting blades need sharpening.
2. Worn counter cutting blade.
Uneven size
1. Worn or damaged hammers.
of shredded
material
2. Stuck hammers.
3. Worn or damaged blades.
4. Blade
Trouble to start
1. Product overloading inside the
the engine
2. Voltage drop in the power
3. Poor fuel quality or carburetor
Smoke in the 1. Excessive oil in the air filter.
gas engine
2. Oil in exhaust system.
exhaust system

Useful Suggestions

revolution below
and counter blade
distance not as recommended.
machine.
grid.
issues.
Solution
Turn shredder off. Remove upper output device, open
cover, remove excess of material from inside the machine.
Close cover, replace output device, turn shredder on,
wait for motor to reach maximum revolution and get
back to work. Control machine intake/feeding.
1. Maintain continuous feeding, yet not overfeeding
which may cause shredder to jam.
2. Check whether TDP rpm is below 540 rpm.
3. Shred dry material only; humid products may block
output device.
1. Sharpen cutting blades as indicated in "Sharpening
and substitution of the knives".
2. Do as item "Counter cutting sharpening and
replacement".
1. Change the hammers' faces or replace them
with new ones, according to instructions in this
manual.
2. Clean the machine whenever you finish chopping
green products, especially before long periods
of interruption, to avoid material buildup in the
cutting disc.
3. Sharpen or replace blades.
4. Adjust blade and counter blade distance as
instructed in this manual.
1. Turn off the equipment and wait for the engine
to stop. Clean the excess of product inside
the machine, start the engine, and wait until it
reaches full speed and resume working.
2. Check the state of the power grid (electrician).
3. Replace fuel or contact an Authorized TRAPP
Technical Assistant.
1. Clean the air filter or replace it.
2. Leave the machine on in an open, ventilated
environment for about 5 minutes, then turn it
off and wait for the exhaust to cool down. When
you turn it on again, you should notice smoke
decrease as you use the machine. If the problem
persists, contact a TRAPP Assistant.
75