Honeywell Guardian Collar Guia Del Usuario página 2

Warning: The choice and use of personal protective equipment must comply with the European Directive No. 89/656/CEE of 30/11/1989. The
employer must have previously analyzed and evaluated the risks resulting from the intervention and to those generated by the use of the
personal protective equipment selected. Fabrics with low air permeability can cause heat stress. Frequent rest is advised.
Preamble / Application: This garment has to be used under the supervision of the person in charge of the intervention who must have ensured
in advance that: this garment offers adequate protection for the category of risks encountered during the intervention; the wearer is in
possession of adequate additional equipment (gloves, respiratory mask, shoes or boots that are compatible with the desired performances); the
entire intervention is supervised and all necessary means of rescue are available in case of an incident in the course of action.
This garment, including gloves, worn with boots and mask gives the wearer protection against: Protective clothing for use against liquid
chemicals - Performance requirements for clothing with spray-tight (EN 14605:2005 / A1:2009 - Type 4).
Area of application: This protective clothing provides the wearer protection against certain liquid chemicals, for a limited period of time. The
resistance against different chemicals is described here below. The nature of the work to be carried and the applicable chemicals together with
the related dangers determine the chemical protective clothing to be worn. If any doubt, the user must contact the product supplier. Prior to use:
the wearer must check that the protection offered meets the conditions for safe use. Ensure that the clothing has been cleaned in the correct
manner (following the previous usage) and inspected as described in this instruction for use. Warning: if any doubt about the correct application,
please contact your supplier or the labour inspection. Fit and adjustment: This garment has to be worn in a manner that, during the work,
maximal protection will be achieved. Close all openings and beware that the hood fits tight to the face (use tape to have the tight junction. The
boots and the gloves have to be worn under the suit. The wearer has to close the hook and loop fastener tape of the wrists around his gloves in
order to adjust the tightness.
the event of a leakage or damage to the cloth material, leave the working environment immediately and remove the suit. After use: Remove the
garment and remove any loss particles with a brush or a cloth. Clean and check the garment as described in the part "cleaning and disinfection"
and "inspection").
Maintenance: Cleaning and disinfection: After each session, clean the garment, using water and a mild detergent (e.g. EW 80 Tremonia
Chemie, Dortmund). The washing temperature for the domestic washing has to be under 30°C. Reduce mechanical action. Do not bleach.
Subsequently, rinse thoroughly with clean water. Do not use solvents. Dry the garment with a cloth and/or leave it to dry in the open air. Do not
use machine drying. Do not iron the coverall. Do not dry clean. Dispose contaminated garment by suitable means (depending on the chemical
subjected to it) Advice: for reasons of hygiene, the garment should preferably be worn by the same person. Inspection: After each cleaning
activity, check the garment for tears, holes or damage to the coating, and the performance of the complete garment. Maintenance: Hood:
Changing the hood will be obtained by opening the zipper situated between hood and collar. Maintenance schedule: Before use: Inspect; After
use: Clean and inspect; Half yearly: Clean and inspect.
Storage & waste management: In the original packaging, out of light and dust, between + 5°C and + 45°C. To avoid the risk of deterioration
(crushing, deformation, etc.), this Personal Protective Equipment should be stored in its initial packaging (cardboard box) until used. Waste
management: Refer to the local legislation.
Important: This garment is not suitable for use during fire extinguishing (flammable material - keep away from fire) or for use in temperature
exceeding 70°C. This garment may only be used by persons who are aware of the dangers relating to the work to be carried out. This user
information does not contain information about additionally attached personal protective equipment, as e.g. gloves, respiratory mask and boots.
Refer to the respective user manuals. To assess the chemical durability the shortest chemical permeation time of a component has to be
considered for the complete system (suit and accessories). This Guardian protective clothing provides the wearer protection against certain
spray chemicals, for a limited period of time.
Ergonomics & safety materials: The materials employed as combined and presented are not hazardous or in any particular respect noxious
(e.g. irritant to the skin) for the wearer of the equipment. The materials used in the manufacturing of the suit do not contain any substances at
levels known or suspected to affect the health or hygiene of the use in the foreseeable conditions of use. However, we ask you to avoid direct
contact between the materials and mucous membranes. For comfort, this coverall should not be worn to the skin but always on top of clothing.
Caution: beware of genes that can result from using this type of equipment (decrease of hearing, freedom of movement...).
LABEL: 1.Name of the Manufacturer; 2. Product name; 3. Protection category; 4. Compliance marking; 5. # of the notified body inspecting the
production (category 3); 6. Reference standards; 7. Consult the Instructions for Use; 8. Size; 9. Batch number, month and year of production;
10. Responsible for distribution;
PERFORMANCES: 1. Raw material performances, 2. Resistance to abrasion, 3. Resistance to puncture, 4. Resistance to flex cracking, 5. tear
resistance, 6. Tensile strength, 7. Resistance to permeation of liquids, 8. NaOH 40%, 9. H2SO4 96%, 10. Seams performances: Resistance to
rupture, 11. Type 4 - Protection clothing against liquid chemicals: spray-tight. Results obtained after 5 domestic washings at 30°C. 12. Cut
resistance.
For more information about performances, please contact Honeywell Protective Clothing. *Resistance to permeation:
NC (Non-classified) < 10 min. / Class 1 > 10 min. / Class 2 > 30 min. / Class 3 > 1 hr. / Class 4 > 2 hr. / Class 5 > 4 hr. / Class 6 > 8 hr.
Caution: The selection of accessories such as boots, gloves and mask should be done consistently with the overall protection sought. The user
should verify the performance offered by such accessories against chemicals (type and concentration).
EN - INSTRUCTIONS FOR USE
The flap mounted on the front side can be used to put an identification label or chemical indicator. During use: In
This suit is not gas-tight and does not protect against micro-organisms (virus, bacteria ...).
11. Washing instructions.
Notice Guardian Collar & Lux - Indice a - Octobre 2012