Troubleshooting; End Of Life Time; Warranty Provisions - Qlima GFA 1010E Instrucciones De Uso

TROUBLESHOOTING

END OF LIFE TIME

If it is decided that the gas heater is not to be used any more, it is recommended
that it be disconnected from the gas container. Also cut the rubber hose. If child-
ren play with the heater, make sure that dangerous parts are removed.
Never dispose of non-biodegradable products in the environment, but dispose of
them in accordance with current national legislation. At the end of its lifetime,
the product must not be disposed of as urban waste. It must be taken to a special
local authority differentiated waste collection center or to a dealer providing this
service.
Disposing of a household appliance separately avoids possible negative conse-
quences for the environment and health deriving from inappropriate disposal
and enables the constituent materials to be recovered in order to make signi-
ficant savings in energy and resources. As a reminder of the need to dispose of
household appliances separately.

WARRANTY PROVISIONS

The appliance is supplied with a 24-month guarantee, commencing on the date
of purchase. All material and manufacturing defects will be repaired or replaced
free of charge within this period. The following rules apply:
4
42
Problem Cause
No electricity supply
The motor does not
work
The safety thermostat
is on
The cylinder gas tap is
closed
The cylinder is empty
The motor works, but
The nozzle is obstruct-
the burner does not
light up and after few ed
seconds the heater
The solenoid gas valve
stops
is not open
There is no spark
No connection with
the earthing system
The burner lights up
Defective connection
but after few seconds
between sensor and
the heater stops
safety device
Defective safety device Replace the safety device
Excessive gas supply
Insufficient air flow
The heater stops
during operation
Insufficient gas supply
due to ice formation
on the cylinder
Solutions
Check the terminal board
with a tester
Wait about one minute then
restart
Open the gas tap
Use a new cylinder
Remove the nozzle and
clean it.
Check that the solenoid
valve works
Check the position of elec-
trode
Check and connect properly
Check and connect properly
Check the pressure reducer
and if required replace it
Check that the motor works
properly
Check and use a larger
cylinder or two cylinders
connected together.