Control Panel; Auto Mode - HQ-Power VDPLDJBAR7 Manual Del Usuario

DMX-512 Connection
 When applicable, connect an XLR cable to the female XLR output of a controller (not incl.) and the other
side to the male XLR input of the device. Multiple devices can be linked through serial linking. The linking
cable shall be a dual core, screened cable with XLR input and output connectors.
 Maximum recommended serial data link distance is 500 meters (1640 ft). Maximum recommended number
of devices on a serial data link is 32 devices.
 A DMX terminator is recommended for installations where the DMX cable has to run a long distance or is in
an electrically noisy environment (e.g. discos). The terminator prevents corruption of the digital control
signal by electrical noise. The DMX terminator is simply an XLR plug with a 120 Ω resistor between pins
2 and 3, which is then plugged into the XLR output socket of the last device in the chain.
9. Operation
The device can be used in the following modes:
 stand-alone mode: automatic or sound-activated
 master/slave
 with a DMX512 controller.
9.1

Control Panel

Access the control panel functions using the four buttons below the display.
Button Function
MENU to access the menu, quit the current function without saving the setting, or quit the menu
UP to scroll upward in a list of functions or options, or increase a value
DOWN to scroll downward in a list of functions or options, or decrease a value
ENTER to confirm and save a selected option or value
Menu name
3-CH
15-CH
Snd
AUTO
S
9.2

Auto Mode

In stand-alone mode, the device runs one of the built-in programs.
To set the device to stand-alone mode:
1. Unplug any connection from the DMX input of the device.
2. Press MENU until <AUTO> is displayed.
3. Press ENTER to confirm.
To set the program speed:
4. Press MENU until <S> is displayed.
5. Use UP and DOWN to set the speed (0 = slowest, 100 fastest).
6. Press ENTER to confirm.
V. 03 – 08/07/2014
VDPLDJBAR7
Options Description
d 1 - 512 Sets the fixture to 3 channel mode.
Use UP and DOWN to set the starting address.
d 1 - 512 Sets the fixture to 15 channel mode.
Use UP and DOWN to set the starting address.
Sets the fixture to sound activated mode.
Sets the fixture to play built-in programs.
S 1 - 100 Sets the speed of the built-in programs (slow to fast)
6 ©Velleman nv