Demounting Tube Type Tires; Mounting Tube Type Tires - Snap-On EEWH329A Instrucciones De Operacion Y Mantenimiento

5.0 DEMOUNTING TUBE-TYPE
TIRES
A. For breaking the bead operate as described for the
tubeless tires in section 4.1, point A to F.
In this case the valve is part of the tube.
NOTICE!
BE CAREFUL NOT TO DAMAGE THE TUBE
DURING THE BEAD-BREAKING OPERATION. THE
VALVE SHOULD BE OPPOSITE TO THE BLADE OF
THE BEAD BREAKER.
B. To demount the fi rst bead, place the valve at 2
o'clock position.
NOTICE!
BE CAREFUL NOT TO CATCH THE TUBE WITH
THE MOUNT/DEMOUNT TOOL, WHEN LIFTING THE
BEAD ON THE MOUNTING FINGER.
After demounting the fi rst bead carefully, remove the
tube before demounting the second bead, as described
in section 4.1.
5.1 MOUNTING TUBE-TYPE TIRES
A. Perform steps described in section 4.2.A. DO NOT
lubricate the tube. Talc can be used to assist with tire
positioning if necessary.
B. Confi rm that the tube is the correct size for the tire
to be mounted. (Fig. 5.1-1).
Fig. 5.1-1
20
C. Infl ate the tube slightly: if held with the index fi nger
it should bend a little (Fig. 5.1-2).
Fig. 5.1-2
D. Mount the fi rst bead as described in section 4.2,
point B. Put the tube inside the tire and connect the
infl ation air line to the tube valve to hold the tube in
place. (Fig. 5.1-3). Mount the top bead following the
directions above.
Fig. 5.1-3
341
Snap-On EEWH329A
342
343