Unit Components - Ferroli SORRISO PC10 Manual De Instrucciones

GENERAL SPECIFICATIONS

UNIT COMPONENTS

1. CABINET FOR THE EXTERIOR UNIT
The cabinet housing the exterior unit is made from galvanised sheet metal hot-painted with polyester powders after pas-
sivation treatment. This makes it resistant to atmospheric agents. The bearing structure is in very thick press-moulded
galvanised sheet metal giving overall rigidity and preventing vibrations from being transmitted.
2. CABINET FOR THE WALL INTERIOR UNIT
The cabinet housing the wall interior unit is entirely made of ABS and also acts as a bearing structure.
3. COMPRESSOR
Depending on the model in question, the compressor in the exterior unit is the highly efficient and silent ROTARY, with
protection against both thermal and electrical overloads. It is fitted on rubber supports to eliminate faults due to vibra-
tions.
4. VENTILATING UNIT
The ventilating unit of the wall unit consists of a tangential fan. This ensures very silent running. The exterior unit is pro-
vided with a helical fan with large blades.
5. HEAT EXCHANGE BANK
In both units the heat exchange bank is made of copper tubing with aluminium sheet fins in a continuous pack. The fins
are directly blocked by the mechanical expansion of the copper tube in order to obtain a high degree of heat transmis-
sion.
6. COOLING CIRCUIT
This is achieved using a copper tubes with seal-tested connections.
7. FILTERING SECTION
The filtering section, located in the interior unit, is made of synthetic material with a high filtering capacity and can be
regenerated by blowing and washing it. The unit is also fitted with an activated carbon electrostatic filter for eliminating
unpleasant odours.
8. REMOTE CONTROL
The air conditioners of this series are provided with an infrared remote control, which allows the appliance to be easily
operated and all parameters controlled.
5