Cleaning And Maintenance - Bestron ART15 Manual Del Usuario

user's instructions
operAtion - use of the clip or base
1. Press the ends of the clip together (see figure 3).
2. Set the clip on a level surface, such as a table.
Put the clip into the base (7) and you have a stand fan.
3. Let the ends go.
Figure 3
Use of the clip or base
operAtion - Ventilation
1. Set the fan on a level surface,
such as a table.
2. Tilt the fan to the required angle
(see Figure 3). You can set the fan:
a. Vertically at a 45° angle. Untighten the
screw at the side of the stand. Tilt the
ventilator housing and motor housing
to the required angle. Tighten the screw.
b. To the left and right (360° around it's axis).
(See figure 4)
3. Put the plug into the wall socket.
4. Switch on the fan by selecting one of the two speeds
with the speed button (4).
a. Position '1', the fan operates at low speed.
b. Position '2', the fan operates at high speed.
5. Stop the fan by setting the speed button at
position '0'.
Figure 3
Tilting the fan

cleAninG And MAintenAnce

1. Remove the plug from the wall socket.
2. Clean the motor housing of the appliance with a damp cloth. After cleaning, dry
3. Store the appliance.
• Verify that the plug is out of the socket before you clean it.
• Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes)
to clean the appliance.
• Do not immerse the motor unit in water, or in other liquids.
45°
360°
17